The screen is a special SHARP screen for the EPAX X1 and X1-N 3D printer ONLY. Using this screen with any other similar LCD printers is not supported.
Since day one, all our 5.5 LCD screens have both SX04(internal default) and SX03 interfaces. The SX04 to SX03 converter is covered/hidden by black tape. To use the screen on EPAX X1-N printers, you will need to carefully remove the black tape on screen’s cable to expose SX04 interface.
The screen has tempered glass installed on top. So even if you spill resin or have a small resin leak, you can gently remove the resin without damaging the screen. Do not leak resin under the screen through edges. It is strongly recommended that you cover the edges with our pre-cut screen tape or with 0.1mm thick kapton tape, if needed.
LCD Screen Specifications
- Size: 5.5″ diagonal
- Resolution: 2560×1440
- Pixel precision: 47.25um
- Display area: 68.04×120.96mm
- Appearance size: 70.94×128.49×1.45mm
- Ratio: 9:16
- Weight: 25.0g
- Interface: MIPI (SX03); MIPI (SX04) inside black tape of the cable
EPAX X1 and X1-DJ use MIPI (SX03) interface.
EPAX X1-N and X1-N-DJ use MIPI (SX04) interface. X1-N and X1-N-DJ have a side window on metal body. You just need to open the window while replacing LCD screen. No need to open bottom panel any more.
Make sure correct interface is used for your printer.
Drive Board Specifications
- HDMI to MIPI
- USB 5V power supply, supporting 2K resolution
- Supports PC and Raspberry Pi
Package Includes:
- 1x 5.5″ LCD screen
- one pre-cut screen tape
