Creality SpacePi X4 filament dryer

Creality SpacePi X4 filament dryer

Creality SpacePi X4 is an efficient, dual-chamber filament dryer that allows you to dry up to 4 spools simultaneously with full temperature control in the range of 45 to 85°C. Thanks to active drying technology, fast heating and quiet operation, you can prepare PLA, PETG, TPU, ABS or PA-CF filaments for printing in a repeatable and stable manner, eliminating the problem of moisture, bubbles and stringing during printing.

Dry different filaments

The device is equipped with two independently controlled heating chambers, allowing you to set different temperatures for different filaments (e.g. 50°C for PLA and 85°C for PA-CF). You can use one or both chambers depending on your needs, saving time and energy in a small workshop or when working with different materials at the same time.

Speed and uniformity

Thanks to its 200W + 200W PTC heaters, the SpacePi X4 heats up to 85°C in about 20 minutes. 360° air circulation ensures even heat distribution, and SpaceDry 4.0 technology with active dehumidification and desiccant regeneration guarantees effective moisture removal without the need to replace cartridges.

Quiet, inexpensive, efficient

The Active Silent system keeps noise levels between just 43-46 dB, allowing for comfortable operation at home and in the workshop. Creality SpacePi X4 offers energy-efficient operation with power consumption of 0.124 kWh in single-chamber mode and 0.208 kWh in dual-chamber mode, reducing the cost of preparing filaments for printing.

Wide compatibility

The Creality SpacePi X4 filament dryer supports spools up to 200 mm in diameter and 150 mm in width with filaments of 1.75 mm and 2.85 mm in diameter. So you can dry both standard 1 kg spools and larger 2 kg spools.

Operational safety

The Creality SpacePi X4’s triple protection system includes fan control, heater temperature protection and sensors that monitor the temperature in the chambers. This allows you to use the device without worrying about overheating or damaging the filaments.

Everyday convenience

The dryer is equipped with chamber lighting, a sliding lock, burn protection rollers and a moisture-proof seal for comfortable use. In addition, the device signals the end of drying with a sound, making it easy to operate.

Control it the way you want

The EDry UI panel allows you to precisely control the drying parameters, including temperature, drying time (1-48 hours) and humidity threshold. You can use automatic modes or your own settings to adjust the drying process to the requirements of a specific filament.

Included:

• Filament dryer
• Power cord
• User manual